Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
RC-X
Art.-Nr.: 3310
17:
REMOTE
2:
SYNC
3,5,6:
SLAVE
HENSEL Studiotechnik
7
Operation
Accessory: Cable Remote Control RC-X
MONO MAX compact flash unit can be operated using the
front panel or in the most important functions using the Cable
Remote Control RC-X, which is available as accessory (Code
No. 3310). The remote control unit will be connected via the
supplied cable to the Remote socket 17 of the compact flash
unit.
The following functions are available on the Remote Control
RC-X:
•
STBY:
•
PILOT:
•
:
•
READY:
•
TEST:
•
Synchronization socket
Synchronization (Flash triggering)
Synchronization by cable
The compact flash unit is connected via the synchronization
sockets 2 to the camera using a synchronization cable with
6,3 mm phone jack.
The synchronization circuit is made up of state-of-the-art
semi-conductor technology and enables secure triggering of
the flash even with older cameras with mechanical contacts.
Due to the many different electrical circuits in cameras for
controlling synchronization, we cannot take any liability for
possible damage to cameras triggering flashes.
Please contact the camera manufacturer before using an
unusual camera.
Synchronization by slave
The compact flash unit can be triggered by the built-in slave 3.
Triggering is then effected by an „incoming" flash, which was
emitted by another flash light. This mode of operation is
switched on using switch 5 and indicated by the yellow light of
the SLAVE ON indicator 6 above the SLAVE switch.
Switching to Stand-by mode
The displays 11 and 16 show „EE/EE"
Operation mode for modeling lamp
OFF or PROP
Flash output adjustment
in 2/10 f-stops over a range of 6 f
Flash readiness control lamp
Manual flash release
user manual MONO MAX
33
Werbung
Kapitel
Inhaltsverzeichnis
