Dishwasher - Indesit d 64 Installation Und Gebrauch

Loading the Dishwasher
Before placing the dishes in the dishwasher, remove the
larger food particles to prevent the filter from becoming
clogged, which results in reduced performance.
If the pots and pans have baked-on food that is extremely
hard to remove, we recommend that they be allowed to
soak before they are washed. This will eliminate the need
for extra wash cycles.
Pull out the racks to facilitate loading the dishwasher.
How to Use the Lower Rack
We recommend that you place the most difficult to clean
items on the bottom rack: pots, pans, lids, serving dishes
and bowls, as shown in the figure to the right.
It is preferable to place serving dishes and lids on the
sides of the racks in order to avoid blocking the rotation
of the top spray arm.
- Pots, serving bowls, etc. must always be placed top
down.
- Deep pots should be slanted to allow the water to flow
out.
- The bottom rack features fold down tine rows (see
figure B) so that larger or more pots and pans can be
loaded.
-The silverware basket can
be doubled (see figure A) so
that only one section may be
used when the silverware
load is light. This also makes
space for additional pots and
pans, and it can also be
placed in the upper rack.
- Silverware should be
placed in the silverware
basket with the handles at
the bottom; If the rack has
side baskets, the spoons should be loaded individually
into the appropriate slots. Especially long utensils should
be placed in the horizontal position at the front of the
upper rack.
How to Use the Upper Rack
The upper rack is designed to hold more delicate and
lighter dishware, such as glasses, coffee and tea cups
and saucers, as well as plates, small bowls and shallow
pans (as long as they are not too dirty).
- Position the dishes and cookware so that they do not
get moved by the spray of water.
How to adjust the Upper rack ...
The top rack can be adjusted using the two rack heights
(top and bottom). To adjust the rack, open up the tabs
that lock the guides and pull out the rack. Arrange the
rack with the back wheels in either the top or bottom
position and then insert it along the guides until the front
wheels are on as well. Close the tabs to lock the rack in
place (see Fig. F).
fig. A
Lower Rack
Load for 12 Standard Settings (For IEC- EN 50242: upper
rack at top position)
Lower Rack
Normal Daily Load
Fig. F
15
Upper Rack
Upper Rack
Fig. B
1
2
3
4
GB