Mat With Non-Slip Surface; Interior Of The Crockery Warmer; What Should I Do If The Crockery Warmer Doesn't Work - AEG KD91403E Gebrauchsanweisung

These products prevent the surfaces
becoming dirty again for some time.
Apply a thin layer of such a product on
the surface using a soft cloth.
On aluminium fronted crockery warmers
use a gentle glass cleaning product and
a soft cloth that does not release fluff.
Wipe horizontally without pressing on
the surface since aluminium is sensitive
to scratches and cuts.
7.2. Interior of the crockery
warmer
Clean the inside of the crockery warmer
regularly using a damp cloth.
8. WHAT SHOULD I DO IF THE CROCKERY WARMER
DOESN'T WORK?
WARNING! Any type of repair
must only be done by a specialised
technician. Any repair done by a
person not authorised by the
manufacturer is dangerous.
Before contacting Technical
Assistance, check on the following:
 The crockery doesn't heat up
enough. Check whether:
 The appliance has been switched
on.
 The appropriate temperature has
been selected.
 The air circulation orifices are
covered by the crockery.
 The crockery was left to heat up for
sufficient time.
If it is very dirty add a few drops of
washing-up liquid to the washing water.
Wipe the surfaces dry using a dry cloth.
Avoid water entering through the air
circulation opening.
Only use the crockery warmer again
when it is completely dry.

7.3. Mat with non-slip surface

The non-slip surface mat can be
removed to facilitate cleaning of the
drawer.
The mat can be cleaned by hand using
hot water with a few drops of washing-
up liquid. Dry thoroughly.
The non-slip mat should only be
replaced when it is completely dry.
 Heating time depends on several
factors, such as, for example:
 Crockery material type and
thickness.
 Quantity of crockery.
 How the crockery is arranged.
 The crockery doesn't heat up at all.
Check whether:
 You can hear the noise of a fan. If
the fan is operating then the
heating element is broken; if the
fan is not operating then the fan is
broken.
 The switchboard fuses / circuit
breakers have fused / tripped out.
The crockery is heating up too

much:
 The temperature selector is broken.
 The on/off switch does not light up:
 The switch's pilot light has blown.
www.aeg.com 13