Saeco Easy Bedienungsanleitung Seite 20

20 INSTALLATION / CIRCUIT LOADING
The messages displayed by the machine during operation are shown
on page 28.
Check that all components
are correctly placed.
See rating plate
Connect the plug placed at
the opposite side of the ca-
ble to an adequate socket.
Wait until a steady stream
of water fl ows out from the
nozzle.
Fill the coffee bean container
with coffee beans.
Move the ON/OFF switch to The machine is warming
"I" to turn on the machine. up; the light is fl ashing.
When the light remains
Turn the knob clockwise
steadily lit, the machine is
to terminate the circuit-
ready for use.
loading process. Remove
the container.
Important warning for using the "Aqua Prima Filter" can be found at
page 28.
The "Aqua Prima" fi lter can Fill the tank with fresh drin-
be installed (see pg.27). king water.
(Optional; it can be purcha-
sed separately).
Place a container beneath
the steam tube.
Put the plug into the soc-
ket placed on the machine
rear.
Turn the knob countercloc-
kwise to start loading the
circuit.
Note: You must load the circuit before starting up the
machine for the fi rst time, if it has been inoperative for a
lengthy period or if the water tank has been completely
The circuit must be also loaded each time
emptied.
the light is steadily lit:
Check the dater on "Aqua Prima" fi lter; if fi lter is past its
date, replace it with a new one.