Auto Off After; Water Filter; Contrast; Factory Settings - Bosch VeroProfessional Gebrauchsanleitung

A
j >
UTO OFF AFTER
3 sec. +
● Turn the knob 6 to enter the time span
after which the appliance should
automatically switch to "energy saving
mode" following drink preparation.
A time between 5 minutes and 8 hours can
be set.
j > W
ATER FILTER
3 sec. +
Before a new water filter is used, it must be
rinsed.
● To do this, press the water filter firmly into
the water tank 11 with the aid of the
measuring spoon 14. Fill the water tank
with water up to the "max" mark.
● Turn the knob 6 to select
press the start button 8.
P 0.5
LACE L CONTAINER UNDER MILK
●
S
FROTHER TART
● Place a container with a capacity of 0.5
litres under the milk frother 10.
● Press the start button 8. Water will now
flow through the filter to rinse it.
● Next, empty the container. The appliance
is ready to use once more.
Note: Rinsing the filter simultaneously
activates the setting for the "change filter"
display.
You can find detailed information about the
water filter in the enclosed filter instructions.
The filter is no longer effective when the
C
HANGE FILTER display appears, or at the
latest after 2 months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance).
Replacement filters can be obtained from
retailers (TCZ7003) or from customer
service (467873).
If no new filter is used, turn the
FILTER setting to
Note: If the appliance has not been used
S
TART and
for a prolonged period (e.g. vacation) the
filter should be rinsed before the appliance
is used again. To do this, simply dispense a
cup of hot water.
j
3 sec. +
The display contrast can be set from
+20
to
● Enter the required setting with the knob 6.
j
3 sec. +
You can cancel your own settings and
reactivate the factory settings.
● To activate the factory settings, press the
start button 8.
Note: The appliance can also be reset to
the factory settings using a combination of
buttons. The appliance must be switched off
fully.
● Hold down the
the on/off switch 1 O / I at the same time
for at least 5 seconds. Press the start
button 8. The factory settings are now
reactivated.
W
N
O .
C
>
ONTRAST
+0
. The factory setting is
> F
ACTORY SETTINGS
< >
and buttons 4 and
en de
ATER
–20
.
31