Inakustik Premium Switch Box 4 in 1 Bedienungsanleitung Seite 9

5. Follow the operational instruction below, and try all the operation function include CEC
control function (Routing Change, One Touch play, Standby)
6. If any function cannot work, please restart the switcher and perform Step 5 again.
Note:
1. Initiate the CEC communication can make sure the switcher collect the correct EDID information from
source device and display device. Incorrect EDID information may cause failure of CEC function. (Due
to varied design of CEC device, some CEC devices will automatically initiate the CEC communication
with the switcher.)
2. The following conditions are recommended to initiate or re-initiate the CEC communication:
 When you first use the HDMI Switcher with your CEC enabled device.
 If you disconnect or change the cable connection order of the connected HDMI source devices.
 If you connect the output of switch box to another TV set.
Please check Step 5 in the connection instruction.
3. The CEC is working under standby mode for all connected CEC supported devices only. Please make
sure the power of all CEC supported devices are plugged in and under standby mode.
4. The CEC feature only works with CEC supported devices.
5. Consumer Electronics Control (CEC) is also known as in following terms by their respective Brand
Name. Philips (EasyLink), Sony (BRAVIA Theatre Sync), Samsung (Anynet+), LG (Simplink), Sharp
(Aquos Link), Panasonic (HDAVI Control, EZ-Sync, and VIERA Link), Pioneer (Kuro Link), Toshiba
(CE-Link and Regza Link), Onkyo (RIHD, Remote Interactive over HDMI), Mitsubishi (NetCommand).
Each brand may have its extend CEC fractures.
6. Under standby mode, the HDMI switcher will memorize the latest input port. At your next use, the
HDMI switcher will detect and connect the latest input port first.
7. To reset the switcher, please unplug the power adaptor, or unplug the power cord from DC jack for
10 seconds or longer; and then plug it back.
8. HDMI 3D video format
Frame packing:
Side-by-Side (Half):
Top-and-Bottom:
CEC Operation
Power ON/OFF & Input Port Selection:
Power on the CEC supported source device (DVD). The Switcher will power on and select to the

proper input port. If the TV set is in standby mode, the TV (CEC supported) will power on, and
change to correct HDMI input port. If you are watching none HDMI source, the TV will change to
correct HDMI input port (One Touch Play)
1920x1080p@23.98/24Hz
1280x720p@59.94/60Hz
1280x720p@50Hz
1920x1080i@59.94/60Hz
1920x1080i@50Hz
1920x1080p@23.98/24Hz
1280x720p@59.94/60Hz
1280x720p@50Hz
OPERATION MANUAL
09