Inakustik Premium Switch Box 4 in 1 Bedienungsanleitung Seite 10

OPERATION MANUAL
 Power on and play other HDMI source devices (CEC supported) which is connected to the switch
box, the switcher will change the input source to the newly active device. (Routing Control)
 Power off (standby) the TV (CEC supported). The switcher and all source devices will turn to
standby mode. (Standby)
 (Note: If the source devices do not support CEC function, the source devices will not turn to
standby mode automatically.)
 All other CEC control features between source device and display device will be passed through.
Please check the manual of your CEC devices for CEC operations. CEC functions may also
support One Touch Record, Deck Control, Tuner Control, Remote Control Pass-through...and
more. If you like to perform these CEC functions above, please check your display and source
devices can both support the CEC functions.
 Switch between different CEC supported source devices. When you turn on and play on the
selected device, the switcher will automatically switch to the selected input port. (Due to varied
design of CEC device, the status of previous source device (DVD) may change to pause, continue
to play, or turn to standby.)
 Enable and disable the CEC function of the switcher: Use the "CEC" button on the remote
controller to enable or disable the CEC function of the switcher. The original setting is CEC
enabled. A blue LED light will indicate the status. Unplug the power and restart the switcher, the
switcher will be set to the original setting.
 Users may also enable and disable the CEC function from their CEC devices (TV, DVD player,
Blu-ray player). Please check user's manuals of the CEC devices.
IR Remote operation
 Use the power key on the IR remote to power on the HDMI switcher, the power indication LED on
the front panel will be lighted on. Press the power key one more time to turn the switcher to
standby.
 Use number buttons to switch between sources.
 Use the "CEC" button on the remote controller to enable or disable the CEC function of the
switcher.
 Batteries
In addition to precautions take care against short circuits (e.g. by isolating the pole with tape).
Manual operation
10
 The "POWER/SELECT" key is a multi function key. Press the button for 2 seconds to turn off the
power (Standby). Press the "POWER/SELECT" key once to turn on the switcher.
 If you want to change the input channel manually, you can only press the key once. There will be
a LED for channel indication.
The procedure is a cyclic function
 When you selected the channel, there will be a LED on to present the channel. If you select
channel 1, the CH1 LED will light on.
must be placed in empty state at the collection points.