Installation - Zanussi ZHC 6121 Benutzerinformation

Installation

Warning! Do not connect the appliance to the mains until the installation is fully complete.
Before beginning the installation process
Extraction mode ONLY
Exhaust outlet selection
The hood is equipped with two exhaust outlets,
one facing upwards (Upper exhaust outlet) and
the other facing backwards (Rear exhaust
outlet).
Both outlets are closed off with pre-cut panels
which, once removed, cannot be replaced. For
this reason you should only choose which outlet
to use once you are completely certain.
Upper exhaust outlet
Press firmly against the pre-cut part closing off
the exhaust outlet and remove it completely.
Rear exhaust outlet
Remove the plastic pre-cut part.
Use a cutter to score along the pre-cut part at
the centre, beginning at the top and working
downwards.
Use a pair of pliers to grip the plastic tabs on the
parts which need to be removed, then push and
pull firmly a few times until you have completely
removed the pre-cut parts. Use a cutter to
eliminate any rough ridges.
58