Safety Instructions; Environment Concerns; Installation - Zanussi ZHC 60156X Benutzerinformation

SAFETY INSTRUCTIONS

For lamp replacement use only lamp type indicated
in the Maintenance/Replacing lamps section of this
manual.
WARNING! Do not connect the appliance to
the mains until the installation is fully complete.
With regards to the technical and safety measures
to be adopted for fume discharging it is important
to closely follow the regulations provided by the
local authorities.
The ducting system for this appliance must not
be connected to any existing ventilation system
which is being used for any other purpose such as
discharging exhaust fumes from appliances burning
gas or other fuels.
Do not use or leave the hood without the lamp
correctly mounted due to the possible risk of
electric shocks.
Never use the hood without effectively mounted
grids.
The hood must NEVER be used as a support
surface unless specifically indicated.
Use only the fixing screws supplied with the
product for installation or, if not supplied, purchase
the correct screws type.
Use the correct length for the screws which are
identified in the Installation Guide.
In case of doubt, consult an authorised service
assistance centre or similar qualified person.
WARNING! Failure to install the screws
or fixing device in accordance with these
instructions may result in electrical hazards.
14

ENVIRONMENT CONCERNS

Recycle the materials with the symbol
. Put the packaging in applicable containers
to recycle it. Help protect the environment and
human health and to recycle waste of electrical and
electronic appliances. Do not dispose appliances
marked with the symbol
waste. Return the product to your local recycling
facility or contact your municipal office department
for household waste or the shop where you
purchased this product.
USE
The hood is designed to be used either for
exhausting or filter version

INSTALLATION

The mains power supply must correspond to the
rating indicated on the plate situated inside the
hood. If provided with a plug connect the hood to a
socket in compliance with current regulations and
positioned in an accessible area, after installation.
If it not fitted with a plug (direct mains connection)
or if the plug is not located in an accessible area,
after installation, apply a double pole switch
in accordance with standards which assures
the complete disconnection of the mains under
conditions relating to over-current category III in
accordance with installation instructions.
Warning!Before re-connecting the hood circuit
to the mains supply and checking the efficient
function, always check that the mains cable is
correctly assembled.
with the household
.
www.zanussi.com