Faults - Causes And Remedies - Beem Kingmop-Superclass Z4.001 Bedienungsanleitung

Troubleshooting

Faults - causes and remedies

Fault
EN
The power indicator
does not light up.
The automatic circuit
breaker in the electri-
cal distribution board
trips
No steam.
48
Possible cause
Plug not inserted into
mains socket.
Automatic circuit breaker in
fuse box tripped.
Too many devices con-
nected to the same power
circuit.
Device is defective.
Device not switched on.
Not enough water in the
tank.
Steam flow set too low.
NOTE
If you cannot resolve the problem with the steps described
►
above, please contact customer service.
Remedy
Insert plug.
Switch on the automatic
circuit breaker again.
Reduce the number of de-
vices on the power circuit.
Contact customer service.
Switch on the device.
Fill the tank, see section
Filling the tank.
Increase the steam flow.
BEEM - Elements of Lifestyle