Lupus LE 180 Anwenderhandbuch Seite 85

NOTE: Select either one of the function [Save the motion snapshot to a JPG file] or
[Save motions to an AVI file on the SD Card], but not both.
5 Use daily schedule:
Un-check
enabled, motion alarm is triggered by any motion-event without setting up the
schedule.
Check : Schedule record applied – motion alarm is triggered only by the
motion-event within the scheduled timeline.
Schedule：
Select time grid ON from time 0:00 to 24:00. Alarm will be triggered by
-
motion-event within the selected timeline (each grid represents half an
hour).
Move the cursor to any white grid area, hold the left button and move
-
the cursor to draw the grid from white to blue. Alarm will be triggered
by motion-event within the selected timeline.
Move the cursor to any blue grid area, hold the left button and move the
-
cursor to draw the grid from blue to white. Alarm will not be triggered by
motion-event within the selected timeline.
Select start and end time, from the starting tome hold the left button
-
and drag along to the selected ending time. This enables multiple grids
to be selected at once.
6 Click [Apply] button to complete the setup.
Click [Apply] button to complete the setup.
NOTE: When the condition of the bandwidth is inadequate, unstable, or SMTP setup is
incorrect. The system may not be able to send the motion event notification by e-mail and
a message appears: "Some Motion Detection JPG files are failed to be sent via email
or upload to FTP due to unstable bandwidth or wrong SMTP/FTP settings. To
ensure you can receive the email or upload to FTP accurately, please make sure the
quality of network or check the SMTP/FTP settings". To ensure that user can
successfully receive e-mail or upload, it is suggested that the user should determine the
quality of the bandwidth and check whether SMTP/ FTP has been correctly setup.
: Schedule record not applied – When motion detection function is
35