Selecting / Changing Sensor En; Time-Controlled Watering - Not Sensor-Controlled - Kärcher Senso Timer ST6 eco!ogic Handbuch

 If a setting is to be changed after initial startup, the relevant sensor must be selected
first. This step is a precondition for all further settings.
esc
menu
Ok
esc
menu
Note
The watering automatically takes place at the preset watering times. ECO delay days are
considered.
Important: If watering is to take place in a sensor-controlled way again, you need to restart
with teaching the sensors by a RESET of the device.
26
Selecting / changing sensor

Time-controlled watering - not sensor-controlled

 Switch into the settings mode using the esc/menu
button.
Sensor 1 is flashing.
 Press the arrow key in order to select between sen-
sor 1 and sensor 2.
 Confirm with the OK button.
 The settings for the selected sensor can now be
made.
 When teaching the sensor, push the esc/menu
button within the 60-second countdown to activate
the time-controlled watering of the relevant valve
outlet.
 Then continue with the entry of the watering time
and watering duration.
See operating instructions.
– 10
EN