Operation Of The Transmitter Using Combio Ja Pulse; Deleting Positions/Deleting Transmitters; Expert Settings; Replacing The Battery - weinor BiEasy 1M Original Bedienungsanleitung

Explanation of functions
2. The blind travels to the save ventilation/turning position. If no
ventilation/turning position is programmed, the blind travels to
the upper end position (not if Combio Pulse is in use).
Operation of the transmitter using Combio JA
Pulse
A Combio 868/915 JA Pulse can be used for the precise adjustment
of the slats for Venetian blind drives.
The preset pulse time of Combio Pulse is cycled by pressing the UP
or DOWN button.
The pulse time can be changed by the user. Keep the STOP and
UP buttons on a programmed transmitter pressed for 6 seconds
for this. The drive starts to move in small pulses. As soon as the
blind has travelled the required distance, release the UP button,
then release the STOP button. The new pulse time is saved. The
new pulse time corresponds to the sum of all pulse times during
the programming of the pulse time. The Combio JA Pulse ends the
programming of the pulse time after 30 pulses.

Deleting positions/deleting transmitters

Deleting the intermediate position from the receiver
1. Press the STOP button and also the DOWN button.
2. Hold this button combination for approximately three seconds.
The status display lights up briefl y.
Deleting the ventilation/turning position from the receiver
1. Press both the STOP button and the UP button.
2. Hold this button combination for approximately three seconds.
The status display lights up briefl y.
Deleting the transmitter channel from the receiver
1. Press the STOP button and also the programming button P (on
the rear of the device).
16 | EN © weinor GmbH & Co. KG

Replacing the battery

2. Keep this button combination pressed for approximately 6
seconds until the status display lights orange briefl y and then
lights red.
The channel in the transmitter is also deleted.
Deleting all transmitters from the receiver
1. Press the STOP button and also the programming button P (on
the rear of the device) + UP button + DOWN button.
2. Hold this button combination for approximately six seconds.
The status display lights orange/green briefl y twice, followed by
red (bidirectional).
The channel in the transmitter is also deleted.

Expert settings

DIP switch 2 on the rear of the device, beneath the cover:
switch up: OFF (bidirectional and unidirectional operation possible,
preset), switch down: ON (only bidirectional operation is possible).
DIP switch 1: OEM setting.
Replacing the battery
Note
Replace batteries only with batteries of
identical type.
1. Unscrew the underside of the device and
open the housing.
2. Remove the batteries.
3. Insert the new batteries in the correct
position.
4. Reassemble the device.
Dispose of used batteries properly.
© weinor GmbH & Co. KG EN | 17