Draining Condensation; Warning Messages; Cleaning And Care; A) General - Sygonix 1456299 Bedienungsanleitung

14. Draining condensation

• When in cooling mode, it is not necessary to install a drainage hose. Make sure both discharge holes (5+7) are
properly closed by the rubber plug.
• When in heating mode, install a suitable drainage hose (internal Ø 15.6 mm; not included) to the top discharge
hole (5). That will increase efficiency. Remove the rubber plug beforehand.
• When in dehumidifying mode, install a suitable drainage hose (internal Ø 15.6 mm; not included) to the top
discharge hole (5). That will increase efficiency. Remove the rubber plug beforehand. Guide the water outside or
into a suitable drain. Also remove the exhaust hose from the product.
• When the internal water tray is full, E4 will appear in the display. In such a case, remove the rubber plug from the
bottom discharge hole (7) to drain the water. You may restart the product afterwards.

15. Warning messages

Display Cause
Short circuit at the temperature sensor or circuit
E1
board.
Short circuit at the copper pipe of the
E2
temperature sensor and at the wiring of the
circuit board.
Water container full.
E4
Rubber plug not installed properly.

16. Cleaning and care

a) General

Under no circumstances use aggressive cleanings agents, cleaning alcohol or other chemical solutions
since these can penetrate the housing or impair functionality.
• Disconnect the product from the power supply before cleaning.
• Clean the product with a dry, fibre-free cloth.
Solution
Repair by expert required.
Repair by expert required.
Drain the water.
Check the correct position of the rubber plug.
Attention! Water could exit from the discharge
hole.
29