Shot Of Steam; Self-Cleaning Function; Automatic Shut Off - Teesa Tsa2010 Bedienungsanleitung

Owner's manual
Shot of steam gives extra steam to remove persistent wrinkles.
1. Move the temperature control at the "MAX" position and wait until the pilot light goes off.
2. Wait few seconds for the steam to penetrate the fiber before pressing again.
NOTE: For the best steam quality, do not use more than three successive bursts at a time.
When using steam for the first time, the button has to be pressed repetitively to activate this
function. Excessive use of this feature will cause the iron to cool down.
Before operating the shot of steam control make sure the pilot light is out.
1. Before cleaning, disconnect the appliance from the mains.
2. Use soft cloth to clean the iron. Do not use solvents or abrasive products as it may damage
this device.
1. Before initiating this function, disconnect iron from the power supply;
2. and fill the water tank to MAX level.
WARNING: Do not fill the tank with other liquids than water. Do not fill the water tank with
vinegar or any cleaning liquids.
3. Next, connect the iron to power supply, turn off steam function and turn temperature
knob to maximum position;
4. place the device horizontally above the sink;
5. and press self-clean button. You can also gently shake the iron. Water will start to pour out
of the iron soleplate.
6. When all water inside water tank has been used, unplug the steam iron from the power
supply socket and leave the iron to cool off.
7. When the iron is cool, treat the soleplate with clean, damp cloth to remove any remaining
impurities and calc flakes.
If the iron is switched on and not moved for a period of 8 minutes while standing on its heel;
or 30 seconds while standing on the soleplate, an internal safety feature will switch the iron
off and the auto-shutoff indicator will blink. Move the appliance sharply to switch it on again.

SHOT OF STEAM

CLEANING

SELF-CLEANING FUNCTION

AUTOMATIC SHUT OFF

13
EN