How To Fill The Water Tank; Steam Ironing - Teesa TSA2010 Bedienungsanleitung

12
cotton with cotton, etc. The iron heats up as fast as it cools, start by ironing the articles
requiring the lowest temperature (such as those made of synthetic fibers), and move
towards those that require higher temperatures.
6. Move the temperature control until it is in front of the appropriate symbol according to
the following:
• position for nylon and acetate
• • position for wool, silk or mixtures
• • • position for cotton or linen (steam)
1. Unplug the iron.
2. Set the steam ruler to dry ironing.
3. Fill the tank through the filling hole.
4. If you have hard tap water, it is advisable to use only distilled or demineralized water; do
not use chemically de-limed or perfumed water.
5. Do not store the iron with water in the tank!
1. Fill the iron as described in the section "how to fill the water tank".
2. Plug the iron into the mains.
3. Steam ironing is only possible when highest temperatures are selected (otherwise, water
may escape through the soleplate).
4. Wait until the temperature light goes out, which indicates that the selected temperature
has been reached.
5. Set the steam ruler to required position.
6. When the ironing is finished, and during breaks in ironing, place the iron in its upright
position.
7. Disconnect the iron from the mains supply. Pour off any remaining water and leave the
EN
iron to cool off.
1. The spray can be used in any position, either in dry or steam ironing, provided the water
tank is filled with water.
2. Press the spray button to release spray.
NOTE: When using spray for the first time, the button has to be pressed repetitively to
activate this function.

HOW TO FILL THE WATER TANK

STEAM IRONING

SPRAY
Owner's manual