Cleaning And Maintenance; Interior Illumination - Change Of The Light Bulb - Eltac Rg 14 Bedienungsanleitung

RoBa_BDA_RG14_RG16_06I13 02.07.13 13:32 Seite 19

Cleaning and maintenance

WARNING: Hazard of injury and burns!
Always unplug the appliance and allow it to
cool before cleaning!
The accessories can be cleaned in warm water with some dishwashing detergent.
The oven is very easy to clean due to its non-stick coating. Wipe the casing, the oven chamber
and the oven door with a moist cloth and wipe dry.
Never immerse the appliance in water and make sure no steam or water can infiltrate the
underside! Do not use a steam jet appliance for cleaning! On no account must you use steel
wool, scrubbing pads, abrasives, solvents or oven cleaners!
In case dirt gets between the glasses of the double-glazed door, you can loosen the 4 screws on
the inside of the door to separate the glasses for cleaning.
Interior illumination – change of the light bulb
In case the interior illumination fails, you can replace the defective light bulb by a new lamp of
the type 230 V ~ 15 W, E14, T 300 °C. Proceed as follows:
• Pull the mains plug and let the appliance cool down completely.
• Loosen the screw above the cover glass of the lamp.
• Take off the cover glass.
• Unscrew the defect light bulb.
• Insert the new lamp (type see above) and screw it in hand-tight.
• Insert the cover glass again and screw it.
Now you can operate the appliance again.
Have a lot of fun when baking, roasting and grilling!
19