Mounting And Electrical Connection - Fakir QS 1800 Bedienungsanleitung

A
This appliance is designed for permanent installation. It must only be installed by
a qualified specialist.
Proceed in the following manner to mount on the wall:
• Remove the two pieces of polystyrene which have been inserted into the front grid for
protection during transport.
• Release the two side screws A of the wall bracket and turn the wall bracket around in
the indicated manner.
• Release the screws B and remove the cover C of the wall bracket. This releases the
swivel limitation and the quartz light can be folded forwards.
• Hold the appliance with the wall bracket horizontally against the wall at the intended
point of installation, and mark the two securing points with a suitable object (pencil).
Be aware of keeping to the minimum distances specified on page 3 !
• Drill two holes at the marked points and insert the dowels.
• Mount the wall bracket on the wall with the two screws and the dowels D.
Electrical connection
• Push the enclosed cable holder into the round opening F on the connection side and
then push the enclosed blind plug into the opposite round opening.
• Push the supply cable through the cable opening F in the wall bracket.
• Connect the power supply cable to the cable terminal E in the manner indicated alon-
gside.
10

Mounting and electrical connection

B
F
A
C
D
E
D