Setting Of The Temperature - Schneider SKG 320.4 A++NF B Bedienungsanleitung

NOTICE! If you use the appliance for the first time or the appliance has
been disconnected from the mains for a longer period of time, allow the
appliance to cool down for 3 until 4 hours on medium temperature setting
(s. chapter 4.4

SETTING OF THE TEMPERATURE

or frozen food in the appliance. If you place food in the appliance before
it has reached its normal operating temperature, this foods can thaw and
/ or spoil.
1. Remove all packaging materials.
2. Adjust the feet and clean the appliance (see chapter
).
MAINTENANCE
3. Do not start the appliance immediately after installation. Wait 4 - 6 hours to
ensure proper operation.
4. The settings of the temperature of both the fridge and freezer can be adjusted
manually by pressing the relevant buttons until the desired values will be
indicated (s. chapter 4.4 S
5. If operation was interrupted, wait 5 minutes before restart.
6. The appliance needs some time to balance temperatures when you have
changed the settings before or when you have stored additional food in the
appliance. The duration of this period of time depends on the range of the
change, the ambient temperature, the amount of food and the frequency of
door-openings. When you set the temperature of both the fridge and freezer
these aspects should be taken into account
7. Operate the appliance according to the instructions described in the following
chapters.
4.4 Setting of the temperature
WARNING! To disconnect the appliance from the mains, you must
unplug the appliance or use a cut-off device.
NOTICE! If you want to switch off the appliance for a longer period of
time, disconnect it from the mains (unplug!). S. also Chapter 7.
D , /
ECOMMISSIONING
 The settings of the temperature of both the fridge and freezer can be adjusted
manually by pressing the relevant buttons (button F
the temperature of the fridge / button F
temperature of the freezer) until the desired values will be indicated (s. chapter
4.2 O
PERATING BUTTONS AND DISPLAY
 When you set a temperature, you set an average temperature for the whole
refrigerator. Temperatures inside each area may vary from the set temperature,
depending on how much food you store and where you place them. Ambient
ETTING OF THE TEMPERATURE
.
TEMPORARILY
).
) before you place any fresh
CLEANING AND
).
(A) for the setting of
RIDGE
(B) for the setting of the
REEZER
74