1. Lift the upper door and remove it carefully (step 1, s. below).
2. Unscrew the screws 3, part 2, and part 1 (s. fig. below).
3. Install part 1 and the additional new part 2 (left door block / in the plastic
bag) on the opposite side using the screws 3 (step 2, s. below).
4. Put the old part 2 (right door block) into the plastic bag.
1
2
3
5. Change the wire from the right to the left slot of the housing (s. fig. below).
S
3:
ECTION
D
OOR HOLDER
D
OOR BLOCK
S
CREWS
63