Blaupunkt 5KD 94190 Montage- Und Gebrauchsanweisung Seite 54

Defect codes
Below defect codes may occur during steam functions :
E-06: 1-Water tank is not close well.
E-05: water system abnormal, need to contact for Engineer to check, below is the possibilities.
1-The water sensor is abnormal.
2-The water pipe is abnormal.
3-The water pump is abnormal.
4-The water tank is abnormal.
1. Auto Scale Removal Function 7
For best cleaning results, we recommend that you use detergent sodium citrate, for descaling steam
microwave oven. Follow the manufacturer's instructions on the packaging. It is suggested that
descaling function should be used after the steam function has been run for 20 hours.
1) Power up the system, remove the water tank, inject 1000ml of fresh water into the water tank,
adding a suitable amount of descaling agent
2) Push the water tank into the appropriate location of the appliance.
3) In standby mode, press „
on weight, cooking time and so on under the d01 mode
4) Press „ „ repeatedly, when „ CLE „ indicator lighten t means to enter Scale Removal
function. "Min" and default time „ 20:00 „ lighten, tank icon show the current water level (Water,
lack of water, full of water), other icons disappear.
5) Press „ „ to start the program.
6) Wait for a minute after the program has finished,remove the water tank and thoroughly clean
the water tank. Thoroughly clean the water tank.)
7) Replace the fresh water, repeat steps 3 to 6.
Note: the des c aling proc e ss shall not be closed. If the des c aling proc e ss shut do w n before the
end, the entire proggram must be started from step 3.
Add water to here
„ button, the display „
54
„ lights and it will show the default setting