Safety Regulations; Proper Use; Technical Data - HERKULES SHZ 250 Bedienungsanleitung

Anleitung_SHZ_125_1000_SPK7:_
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety regulations

CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
1. Always check that the mains voltage is identical
to the voltage quoted on the rating plate. In the
event that the mains voltage is not suitable, it
may cause the machine to work abnormally and
thus result in personal injury.
2. The power supply must be earthed and be
secured by a residual current operated circuit
breaker (RCCB).
3. Do not attempt to lift loads that exceed the rated
load.
4. Use the equipment only for the purpose for which
it is designed. Never transport personnel using
the cable hoist.
5. Do not pull the power cable in order to pull out
the plug. Protect the power cable from heat, oil
and sharp edges.
6. Never attempt to transport fixed or jammed
loads.
7. Pull out the plug when the cable hoist is not in
use.
8. Keep children and other unauthorized persons
away from the machine.
9. Do not pull loads sideways or from one side. Do
not allow the load to swing.
10. Ensure that the hook moves in the same
direction as shown on the control switch.
11. Check the cable hoist at regular intervals for
signs of damage. The control switch must be in
good condition.
12. Have repair and servicing work carried out only
by authorized workshops by a trained electrician.
16.10.2008 16:07 Uhr Seite 11
Repair work must only be carried out by a trained
electrician, otherwise the machine may cause
accidents.
13. Do not switch the machine on and off quickly
(inching mode).
14. Always concentrate fully when operating the
cable hoist.
15. Do not stand or work under the raised load.
16. Wear a protective helmet.
2. Layout (Fig. 1-2)
1. Fastening bar
2. Fastening hole for hook
3. Drum
4. Lever for maximum cable length
5. Automatic stop mechanism lever
6. Steel cable
7. Cut-out weight
8. Hook
9. Emergency Stop switch
10. Pushbutton
11. Remote control
12. Power cable
13. Control cable
14. Motor
15. Return roller
16. Additional hook

3. Proper use

The cable hoist is designed for lifting and lowering
loads in enclosed areas commensurate with the
machineʼs capacity.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Be sure to observe the information specified in
the technical data.
The rated load does not depend on the winding
layers.
GB
11