Specifications - Makita SG1250 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Shaft lock
2-1. Notch
3-1. Scale
3-2. Clamping screw
4-1. Slide switch
5-1. Hex socket head bolt
6-1. Blade case
6-2. Base

SPECIFICATIONS

Rated speed (n) /
No load speed (n )
0
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting tracks in concrete walls or
cutting in ferrous materials or concrete drainage
channels with a diamond wheel but without using water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : concrete cutting
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
7-1. Shaft lock button
7-2. Lock nut
7-3. Lock nut wrench
8-1. Diamond wheel
8-2. Blade case
9-1. Front handle
9-2. Hex socket head bolt
10-1. Dust nozzle
Model
Wheel diameter
European countries
Other countries
Spindle thread
Overall length
Net weight
Safety class
) : 102 dB(A)
pA
) : 113 dB(A)
WA
2
) : 4.0 m/s
h
2
ENE026-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENF002-2
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENG905-1
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
ENG900-1
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Wall Chaser
Model No./ Type: SG1250
are of series production and
4
10-2. Vacuum cleaner
10-3. Hose
11-1. Hex wrench
11-2. Front handle
12-1. Base
13-1. Inhalation vent
13-2. Exhaust vent
SG1250
125 mm
-1
10000(min )
-1
9000(min )
M14
346 mm
4.4 kg
/II
Corporation as the
ENG901-1
ENH101-15
responsible