Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Attention: The operation of warning beacons in Germany is permitted only in non-public areas.
Use in public traffic (streets, roads, and plazas) is prohibited!
This prohibition applies also to areas immediately adjoining public traffic, since an endangering of
INSTALLATION
Attachment
Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: The holes for the installation are on the mounting brackets of the baseplate.
Step 2: Hold the baseplate onto the location where the device is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the baseplate in the desired position and tighten it.
The device can be installed on the ground or on the wall or ceiling.
OPERATION
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
After you connected the effect to the mains, the EUROLITE LED Policelight classic starts running.
Via the rotary-control, you can adjust various rotation speeds.
the traffic flow cannot be excluded!
9/10
00084878.DOC, Version 1.0
Werbung
Inhaltsverzeichnis
