Safety Notes; Operation - Monacor PA-1200RDSU Einbau- Und Bedienungsanleitung

3 Safety Notes

The module corresponds to all relevant directives
of the EU and is therefore marked with
•
The module is suitable for indoor use only .
Protect it against dripping water, splash water
and high air humidity . The admissible ambient
temperature range is 0 – 40 °C .
•
Do not operate the unit with the integrated
module
1 . if the module or the unit is visibly damaged,
2 . if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3 . if malfunctions occur .
In any case the module or the complete unit
must be repaired by skilled personnel .
•
For cleaning only use a dry, soft cloth; never use
water or chemicals .
•
No guarantee claims for the module and no
liability for any resulting personal damage or
material damage will be accepted if the module
is used for other purposes than originally in-
tended, if it is not correctly installed or operated,
or if it is not repaired in an expert way .
If the module is to be put out of oper-
ation definitively, take it to a local recy-
cling plant for a disposal which is not
harmful to the environment .
4 Installation of the Module
WARNING
The module must always be in-
stalled by experts; otherwise, you
will risk an electric shock .
1) Disconnect the unit (PA amplifier / extension)
into which the module is to be installed from
the power supply and unscrew the cover of
its housing .
2) On the front of the amplifier / extension, un-
screw the plate covering the insertion compart-
ment . Insert the module into the compartment
and screw it on .
3) The 3-pole connection CON IN OUT (at the rear
edge) supplies the module with its operating
voltage (17 V) and sends the audio signal to the
amplifier . Connect the three-pole line of the
amplifier/extension to this connection .
4) For installing the antenna jack provided,
.
remove the cover plate "ANT . Terminal" on
the rear of the amplifier / extension . Insert the
antenna jack into the opening and screw it on .
AM GND
ANT. Terminal
(option)
5) Connect the line of the inserted antenna jack
to the 5-pole connection ANT1 of the module .
6) Close the housing cover of the unit into which
the module has been inserted . Connect the
reception antenna to the antenna jack . A basic
wire antenna is supplied with the module .
When using both an FM antenna and an
AM antenna, connect the antennas to the jack
ANT via an antenna combiner .

5 Operation

1) Switch on the unit into which the module has
been inserted . Use the button /
on the module .
2) Press the button MODE to switch between
radio and audio player .
3) Use the control LEVEL to set the desired vol-
ume .
4) To switch off, keep the button /
until the display goes dark . Alternatively, switch
off the unit into which the module has been
inserted .
The next time the module is switched on,
all functions selected will be activated again .
5.1 Operation of the audio player
To replay MP3 files or WMA files, connect a USB
flash drive or a USB hard disk with separate power
supply to the USB port . With a corresponding
USB adapter, memory cards (SD, SDHC) can also
be used .
Note: Due to the large number of storage device manu-
facturers and device drivers, it cannot be guaranteed that
all storage media are compatible with the PA-1200RDSU .
FM 75 Ω
300 Ω
ANT
to switch

pressed

9