Install The Wall-Mount - WEEE YUNO-151 Bedienungsanleitung

3.5 Install the Wall-mount

YUNO follows VESA Mounting Interface Standard to allow you to mount the elegant
bezel-free panel PC to a stand or wall with four M4 screws easily.
The horizontal and vertical distance between the tapped holes on YUNO is 75 mm.
Make sure the system is powered off before starting.
Please follow the below steps to get it ready for the mounting process :
1. Remove the System Cover.
To open the System Cover, please refer to the procedures described in Chapter
3-1, and remove it.
2. Remove the L-Stand Cover.
3. Detach the panel PC by unscrewing the10 pcs of screws from the L-Stand Cover.
4. Remove the 4 pcs of rubber cap from the System Cover.
16