Replace The Storage Disk Drive - WEEE YUNO-151 Bedienungsanleitung

3.2 Replace the Storage Disk Drive

YUNO offers two 2.5" drive bays of height 7 mm each to allow you to equip it with a
configuration of one primary HDD or SSD on the upper bay and one secondary SSD on
the lower bay.
*Please note that if you are replacing your only HDD or SSD, you will need to reinstall
your operating system after replacing it.
Make sure the unit is powered off before starting.
Please follow the below steps to finish the replacement :
1. Remove the System Cover
To open the System Cover, please refer to the procedures described in Chapter
3-1 and remove it.
2. Remove the old drive (if applicable).
If you are removing a HDD or SSD, make sure all of the cables are disconnected
from both the motherboard and the power supply. Rotate the Releasing Handler to
unlock the storage disk drive and slide it out of the housing.
3. Insert your new drive.
Remove it from the antistatic packaging and slide it into your target drive bay of the
storage housing.
10