Klarstein Omnichef-45 Bedienungsanleitung Seite 10

Function Step
Convection 1
Hot plates 1
2
3
Bake 1
2
3
4
5
Broil 1
2
3
4
5
1
Toast
2
3
4
Instruction
It can choose the convection time and temperature of heating. This convection
control works only when function control set on Convection switch position.
Place a pot or pan onto the desired hotplate and start cooking.
Turn the timer to choose timer for cooking.
Turn the top knob to choose the hot plate.
IMPORTANT: It is not possible to operate both hotplates at the same time when
the oven is working. Do not leave the appliance on without any pot or pan on the
hotplate .This will damage the hotplate and cause excessive heat.
Place the removable rack into the desired position.
Place the bake pan on the wire rack. Shut off the oven door.
Turn the timer dial to the desired cooking time.
Turn the thermostat dial for the desired temperature.
When finished baking, turn the time dial till position "0ff", to switch off the oven.
Insert the removable wire rack with food and the all-purpose pan.
Keep the door half-open.
Turn the timer dial to the desired cooking time.
Turn the thermostat dial for the desired temperature.
When finish broiling, turn the timer dial till position "0ff" to switch off the oven.
Set the temperature control to 250.
Place food to be toasted on the Bake Rack.
Turn the Time Control to desired darkness. Bell will ring to signal the end of the
Toast cycle.
When finish cooking, turn the timer dial till position "0ff" to switch off the oven.
10