Connecting The Power Supply; Installing The Label Tray - Brother QL-1060N Bedienungsanleitung

4
Close the DK Roll compartment cover until it
clicks on both sides.

4 Connecting the Power Supply

Connect the power cord to the
QL-1060N and then plug the power
cord into a electrical outlet.
Check that the electrical outlet is
•
220V-240V AC before plugging the
power cord.
Unplug the power cord from the
•
electrical outlet after you have finished
using the QL-1060N.
Do not pull the power cord when
•
unplugging it from the electrical outlet.
The wire in the power cord may
become damaged.
Do not connect the QL-1060N to the
•
computer until directed to do so when
installing the printer driver.

5 Installing the Label Tray

The machine contains a label tray
which can hold up to 10 individual
label sheets.
As shown right, install the label tray
to the front face of the machine.
When printing more than 10 labels
•
continuously using the auto cut
function, remove the paper guide to
prevent a paper jam.
9
STEP
1
STEP
2
STEP
3
STEP
4