Brother QL-1060N Bedienungsanleitung Seite 22

20
STEP2 Installing the Software
Installing the BRAdmin Light configuration utility for Mac
BRAdmin Light is a utility for the initial setup of Brother network connected devices. It can
also search for Brother products on your network, view the status and configure basic
network settings, such as IP address.
For more information on BRAdmin Light, visit us at http://solutions.brother.com.
If you are using Personal Firewall software, BRAdmin Light may fail to detect the
unconfigured device. In that case, disable your Personal Firewall software, try
BRAdmin Light again. Re-start your Personal Firewall software after the address
information is set.
1
Double click [BRAdmin Light.pkg] in the
[Mac OS X] folder.
The BRAdmin Light Installer starts up. Follow the
on-screen instructions.
2
When the installation is completed and
the message "The Software was
successfully installed." is displayed,
click [Close].
The installation of BRAdmin Light is completed.
Setting your IP Address, Subnet Mask and Gateway using
BRAdmin Light
1
Click [Library]-[Printers]-[Brother]-[P-touch
Utilities]-[BRAdmin Light.jar].
BRAdmin Light will search for new devices
automatically.
If you have a DHCP/BOOTP/RARP server in your
network, you don't have to do the following
operation, as the print server will automatically
obtain its IP address.
2
Double-click the unconfigured device.