Settings - Inline 4 x 4 MultiView HDMI Matrix Anwenderhandbuch

Settings

1. To bring up the setting menu, press Enter button on
the keyboard or MENU/SELECT button on the front
panel of unit or remote control.
2. Press / button to move the cursor, press
to select the desired option, and then press MENU/
SELECT to confirm the selection.
Item
System
Video Wall
PAP
Output resolution Output A/B/C/D
EDID Configuration
14
Options
OSD timeout
Title bar timeout
OSD output
Shrink control
Channel name
Load factory default
Firmware date
Layout
Bezel
Layout
/
Description
Setup the timeout of OSD.
Setup the timeout of title bar.
Output OSD to all displays or display A only.
Select Full screen to fill the entire screen. The screen may
be stretched.
Select Keep ratio to remain the original aspect ratios. The
black bars may appear on top-bottom or left-right sides of
screen.
Change the name of video source using uppercase,
lowercase or digits up to 16 characters.
Restore to the factory default.
Display the version of firmware.
Select a preferred video wall layout.
Adjust the compensation for bezel between panels.
Select a preferred PAP layout.
Specify a display and set the desired output resolution. By
default, the resolution of all displays will be set to the best
resolution of display A. Resolutions can be set individually
for each display only in Matrix mode.
Select a preferred EDID of display for input source.
OSD timeout 00
Title bar timeout 00
OSD output All
Shrink control Full screen
Channel name
Load factory default
Firmware date 140926
Sec
Sec