Display Mode Menu - Inline 4 x 4 MultiView HDMI Matrix Anwenderhandbuch

Rear panel
12
No. Item
12 2-position power
switch
13 Power jack
14 USB Type A
receptacles
15 RS-232 connector Connect to a computer or RS-232 device.
16 USB Type B
receptacles
17 HDMI OUT A~D
18 HDMI IN 1~4
19 IR EXT
* Firmware update
To update the firmware, please follow the steps below:
1. Press the power switch to turn off the power.
2. Press and hold the SET button, then turn the power switch to on. The SET button will be blinked
rapidly.
3. Plug the USB cable into the USB Type B receptacles. The procedure of updating will be started.
4. Once the procedure of updating has been completed, a reminder message will be appeared on the
screen and the blinking of SET button will be stopped.
Please contact local dealer or distributor if you have trouble updating the firmware.

2. Display mode menu

The display mode menu is a way of control using mouse. Please follow the steps below to select a
desired mode, input and output.
1. Simply click the mouse wheel anywhere on the screen to bring up the display mode menu.
Matrix
2. Point the preferred mode to bring up the drop down menu.
The selected mode will be highlighted by red color, and the
corresponding options will be shown on the drop d0own menu.
3. Left click to tick the desired option or left click again to cancel. In
Windows mode, left click to turn on or off the windows.
4. To exit the display mode menu, press mouse wheel again.
13 14 15
Description
Press to power on/off the unit.
Connect to the power adapter (DC 12V).
Connect to USB keyboard and mouse.
Connect to a computer for updating firmware*.
Connect to HDMI displays.
Connect to HDMI source devices.
Extend ability of remote control using 3.5mm jack extension cable.
PIP Windows
16 17
Video wall
18
PAP Quadview
1
3
4
Example: Windows mode
19
2
7