Noise/Vibration Information; Machine Elements - Bosch GWS 8-115 PROFESSIONAL Bedienungsanleitung

1 609 929 J28.book Seite 2 Donnerstag, 18. August 2005 1:54 13
Speed Preselection (GWS 11-125 CIE/GWS 14-125 CIE)
Material Application
Plastic Polishing
Finish polishing
Metal Finish grinding
Removing paint
Wood, metal Brushing, removing rust
Metal, stone Grinding
Metal Roughing
Stone** Cutting**
** Cutting of stone is permitted only with the cutting guide (accessory).

Noise/Vibration Information

Measured values determined according to
EN 60 745.
Typically the A-weighted noise levels of the
machine are: sound pressure level 90 dB (A);
sound power level 101 dB (A). Measurement
uncertainty K = 3 dB.
Wear hearing protection!
When using the standard auxiliary handle, the
typically weighted maximum acceleration is
2
4.0 m/s .
When using the vibration-damping auxiliary han-
dle, the hand-arm vibration is typically lower than
2
2.5 m/s .

Machine Elements

The numbering of the machine elements refers to
the illustration of the machine on the graphics
page.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 Release lever
2 Spindle lock button
3 Thumbwheel for speed preselection
(GWS 11-125 CIE/GWS 14-125 CIE)
4 On/Off switch
5 Auxiliary handle
6 Grinder spindle
7 Extraction hood*
8 Mounting flange with O-ring
9 Carbide grinding head*
10 Clamping nut
11 quick-clamping nut*
12 Protection guard
13 Grinding/cutting disc*
18 • 1 609 929 J28 • 05.09
Tool
Lamb's wool bonnet
Felt polishing disc
Buffing disc
Sanding sheet
Cup brush, sanding sheet
Grinding disc
Grinding disc
Cutting disc and cutting guide
14 Hand guard*
15 Rubber sanding plate*
16 Sanding sheet*
17 Round nut*
18 Cup brush*
19 Cutting guide with dust extraction
protection guard*
20 Diamond cutting disc*
* Not all of the accessories illustrated or described are
included as standard delivery.
For Your Safety
Read all instructions. Failure to
follow all instructions listed below
may result in electric shock, fire
and/or serious injury.
Additionally, the general safety instructions either in
the enclosed booklet or those added in the centre
of these operating instructions must be observed.
SAVE THESE INSTRUCTIONS.
Wear safety goggles.
Wear hearing protection.
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
securely than by hand.
Take protective measures when dust can
develop during working that is harmful to
one's health, combustible or explosive. Ex-
ample: Some dusts are regarded as carcino-
genic. Work with dust/chip extraction and
wear a dust mask.
English - 2
Thumbwheel
1
1
1
2 – 3
3
4 – 6
6
6