Coffee Preparation - WMF STELIO Gebrauchsanweisung

Start-up
Prior to the initial use and after the device has not been used for an extended period
of time, carry out a brewing process with fresh water and no ground coffee. To do
so, fill the tank (4) to the 8-cup mark (version with glass jug) or to the 6-cup mark
(version with vacuum jug), as otherwise the jug (7) can overflow.

Coffee preparation

Open the water tank (4). To do so, swing open the lid (3) upward. Only pour cold
water into the tank (4). The water level indicator (5) is for the amount of fresh water
that is needed to brew the desired number of cups per 125 ml of coffee.
Open the filter (2) by swinging open the filter lid (1) upward. Place the paper filter
of the 1 x 4 size into the filter (2), but fold the stamped edge before doing so. The
paper filter should not protrude over the edge of the filter, which is why it should be
pushed down slightly with your hand.
Fill with the required amount of ground coffee. Depending on personal taste prefer-
ences, approximately 5-7 g of medium-fine ground coffee is estimated per cup. If it
is ground too finely, the filter (2) may overflow.
Then close the filter lid (1). It will audibly click into place.
Insert the mains plug into the socket and push the Start / Stop button (6). This
illuminates blue and the preparation begins.
You can cancel the preparation at any time by pressing the Start / Stop button (6)
again.
Wait a few minutes until all of the coffee has run into the jug (7). After removing
the jug (7), a drip-stop valve prevents coffee from dripping.
Keep-warm function
(only version with glass jug)
In order to keep the finished brewed coffee at a serving temperature, your device
is equipped with a keep-warm function. After the preparation is complete, the
keep-warm function activates automatically and the Start / Stop button (6) remains
illuminated blue. The keep-warm time is 40 minutes. Then the device automatically
switches off and the Start / Stop button (6) turns off.
You can deactivate the keep-warm function at any time by pressing the Start / Stop
button (6).
Automatic shut-off
(only version with vacuum jug)
After being switched on, the automatic shut-off ensures that the device does not
overheat. Only once the water has completely passed through does the device switch
off and the Start / Stop button (6) is no longer illuminated.
It is possible to shut off the coffee maker early by pressing the Start / Stop button
(6). This could be necessary if you accidentally start the coffee machine without
water. It is necessary to wait for a few minutes before you add more water into the
hot device. Allow the coffee machine to cool beforehand.
12