Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
VACUUM & SPRAY
Instructions of use vacuum
1. Connect the opposite side of the pipe in the vacuum
handle. Put the properly small glass vacuum pipe in
the handle. There are four types of small glass vacuum
pipes.
2. Check that the foam filter is in its properly position
in the handle.
3. Press " STATE" to select vacuum function
4. According to the needs, adjust the output level by
pressing "ENERGY" and desired time of operation by
pressing "TIMER".
5. Press "START/PAUSE" to start working.
6. You can adjust the suction effect by covering or
uncovering the lateral hole of the handle with your
finger.
7. After performance completed, first turn off the unit
by pressing "START/PAUSE" button.
Notes
Normal performance should not last over 5 minutes,
in the event that the instrument is overheated, please
turn off all buttons and restart in 10 minutes.
Cautions
Do not leave the handle on the same part of skin for
too long since it can cause injuries.
Avoid using in on irritated skin.
Always make sure the spray pipe is connected to the
right nozzle of the machine, to prevent accidental
vacuuming of any spray solution into the pump, which
can damage the pump of your machine and void your
manufacturer's warranty.
Do not work the vac/spray pump for extended
periods without cool-down time between treatments
in order to prevent over heating of the pump and
damage to the machine. Damage caused by
overheating of the pump is not covered by the
manufacturer's warranty.
Instructions of use spray
1. Fill the spray bottles with the proper liquid. There
are two spray bottles, which can contain different
liquids.
2. Connect the opposite side of the pipe to the spray
bottle.
3. Press " STATE" to select spray function
4. According to the needs, adjust the output level by
pressing "ENERGY" and desired time of operation by
pressing "TIMER".
5. Press "START/PAUSE" to start working.
6. You can adjust the spray effect by covering or
uncovering the top hole of the bottle with your finger.
7. Once you have finished, first turn off the unit by
pressing the "START/PAUSE" button.
Notes
Spray downwards from the forehead during
operation. Stop the liquid from going into the nose. Ask
the customer to close their eyes and shut their mouth.
Maintain an adequate distance from the face whilst
spraying so that the effect is felt as a gentle mist
landing on the skin.
Normally the operation should not last more than 5
minutes. If the instrument overheats, turn off all the
buttons and restart after 10 minutes.
Werbung
Inhaltsverzeichnis
