Canton Digital Movie 5 Bedienungsanleitung Seite 55

Problem Possible cause
DM system does not Power cable not connected to the power outlet
turn on. and / or DM system
The DM system 1. The preset (factory setting) for the AUT
does not switch on function is OFF (disabled).
automatically from
2. The DM system was switched off via the
the optical or coaxial
"ON / Standby" key of the soundbar remote
input.
control or the "Power" key of the TV remote
control (using the IR learning function).
3. The DM system was switched to the other
digital input which receives no signal and has
switched itself off automatically.
The DM system 1. The ECO function is activated (ON).
switches into standby
2. The AUT function is activated (ON).
autonomous.
3. The infrared command for standby (STB)
has been learned incorrectly.
The DM system 1. The ECO function has been deactivated.
doesn't enter standby
2. The AUT function is still deactivated.
mode automatically.
3. The AUT function has been activated but the
source sends a carrier even in standby mode.
Solution
Prepare connection.
1. Activate the AUT function (ON) (Page 48).
2.1. Switch on the DM system via the "ON / Standby" key on
the remote control and wait in future until it switches
automatically to the standby mode.
2.2. Delete the "Power" key of your TV remote control from
the DM system so that you do not turn it off along with
your TV.
3. Switch the DM system on using the "Power" key on
the remote control and select the digital input that is
connected to the desired source device.
1. Deactivate the ECO function (Page 49).
2. Deactivate the AUT function (Page 48).
3. Learn the command for standby (STB) correctly (Page 51).
1. Activate the ECO function (Page 49).
2. Activate the AUT function (Page 48).
3. Disconnect the source from the mains resp. set the
DM system into standby mode manually.
English
3 5 5