Ir Learning Function - Canton Digital Movie 5 Bedienungsanleitung

IR learning function

The DM system can learn the infrared code of your TV remote control and therefore allows you to control the functions of the Soundbar
and TV device via one remote control. You can allocate any key of the TV remote control to the soundbar. When choosing a key make
sure that the instructions for the Soundbar do not conflict with the TV device. We recommend that you deactivate the internal loudspeaker
of the TV device once the Soundbar is connected.
Hold the TV remote control in position.
1
Switch the Soundbar on.
2
Press and hold the "On / Standby" key of the Soundbar
3
remote control for approx. 5 seconds.
The display shows a flashing
4
Press the wanted function on the Canton
5
remote control e.g. "Volume +".
Now the display shows the chosen function, e.g.
6
Within 20 seconds press the key you wish to allocate
7
to this function on the TV remote control.
Once this has been successfully allocated the display
8
will show and you can continue with the
OK
programming of the next key function, e.g. "Volume –".
If the display shows
FAI
9
has failed and you need to repeat steps 5 to 8.
IRL .
.
this means the allocation
ON
STANDBY
Note: The red "On / Standby" key on the DM remote control has
a dual function. Press it once and the display will show
which allows the switching on function to be programmed. If the
red "On / Standby" key on the DM remote control is pressed twice
in quick succession the display will show
resp. switching off function can be programmed. If your TV remote
control has only one key for the "On" and "Off" functions both
the "On" and "Standby" functions must still be allocated with this
command.
English
MUTE
TV remote control
ON
and the Standby
STB
3 5 1