Mitsubishi Electric MAC-567IF-E Installationshandbuch Seite 8

When mounting on the outer side of indoor unit
• Insert the clip into the holder until it clicks.
• Insert the interface unit into the holder until it clicks.
Note: When inserting the interface unit into the holder, align the cable of the Interface unit
with the mark for the cable on the holder .
Otherwise, light leakage or degradation in appearance may result.
Holder
• Slip the clip over the edge of corner box to fix the interface unit .
Note: Mount the interface unit
mounted on the side of the indoor unit.
Example of mounting on the left side of indoor unit
Note: Interface unit can also be mounted on the right side of the indoor unit.
Underside of the Indoor unit
Indoor unit
Corner box
• To check the LED indication after setup, remove the interface unit from the holder .
Run the connecting cable in the space on the back of the unit as shown in the above figure.
Tuck cabling away and secure it.
Note: Make sure that the connecting cable will not get caught on or between the installation plate and
the wall, or between the indoor unit and the installation plate.
Failure to do so may cause damage to the connecting cable resulting in communication problems.
GB-7
Mark for cable
Interface unit
Clip
Connecting cable
on the underside of the indoor unit if it cannot be
Corner box
Holder
Interface
unit
Clip
Side of the Indoor unit
Indoor unit
Corner box
Align