Mitsubishi Electric MAC-567IF-E Installationshandbuch Seite 7

4. Connecting the Wi-Fi interface
(For details on each system, see the relevant instruction manual.)
Turn off the breaker of the room airconditioner or the ATW unit before connecting the cable to the
indoor unit.
Refer to the installation manual of each model for connecting instructions and details.
(1) The connecting cable connected to a indoor unit (CN105) should be mounted at the indoor unit or
its vicinity.
When mounting the Interface unit
the indoor unit. Do not mount the Interface unit
<Room air conditioner>
When mounting on the wall
The cable side of the interface unit should face downward.
Taken out from
the left side
• Mount the holder on the wall so its mark for the cable faces downward.
• Insert the interface unit into the holder until it clicks.
Note: Tighten the upper and then the lower screws; adjust and level the holder using the
elongated hole for the lower screw.
Holder
Mark for cable
inside an indoor unit, refer to the installation manual of
inside the indoor unit, if not mentioned.
Indoor unit
Screw fix
Adjustment
Mark for
cable
Taken out from
the right side
Holder
Interface
unit
Connecting
cable
Wall
Screw
Screw
Mount-
ing cord
clamp
GB-6