Transport And Storage - Hilti PRA 90 Original Bedienungsanleitung

7 Care and maintenance
Note
Observe the temperature limits of ­25 °C (-13 °F) to +60 °C (140 °F) if you keep your equipment inside
a motor vehicle.
• Always keep the threaded rod free from coarse dirt and concrete residues.
• Use only a clean, soft cloth for cleaning. If necessary, moisten the cloth slightly with pure alcohol or
water. Do not use any other liquids as these may affect the plastic parts.

8 Transport and storage

Transport
CAUTION
Unintentional start-up during transportation. If batteries are left inserted, the tool may start up
unintentionally during transportation and the therefore may be damaged.
▶ Always transport the tool with the batteries removed.
• After use, wind the threaded rod down fully.
• Remove the battery.
• Only now fold in the tripod legs.
• For transporting or shipping your equipment, either use the Hilti shipping box, the Hilti transport pouch
or an equivalent form of packaging.
• Always check the accuracy of the equipment before it is used after a prolonged period of transportation.
Storage
CAUTION
Unintentional damage caused by defective batteries. Leaking batteries may damage the tool.
▶ Always store the tool without the batteries inserted.
• Store tools and appliances in a dry place where they cannot be accessed by children or unauthorized
persons.
• Remove the tool from its case if it has become wet. Tools, carrying cases and accessories should be
dried and cleaned at a maximum temperature of 40 °C (104 °F).
• Repack and store the equipment only once it is completely dry.
• Always check the accuracy of the equipment before it is used after a prolonged period of storage.
• Store the battery in a place that is as cool and dry as possible.
Never store the battery where it is exposed to direct sunlight or sources of heat, e.g. on heaters /
radiators or behind glass.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
Tripod does not respond.
Tripod cannot be switched
on.
Automatic alignment not suc-
cessful.
18
Possible cause
Tripod not switched on.
Tripod not paired.
Batteries in the PRA 92 empty.
Battery not fully inserted or empty.
The desired height is outside the
maximum possible setting height.
Excessive vibration from external
influences.
Action to be taken
▶ Switch on tripod.
▶ Pair the remote control unit with
the tripod.
▶ Replace the batteries.
▶ Insert the battery so that a
"click" is heard or charge the
battery.
▶ Check the adjustment height.
▶ Completely unfold the tripod
and check that it stands firmly.