Grundig FS 4820 Handbuch Seite 23

USING WITH THE FACE MASK
3
Put the face mask on the basic
appliance and turn to tighten
clockwise.
close
4 Plug the power cord into the wall
socket.
Note
For the maximum amount of
7
water, the steam takes about
20 minutes to develop.
Use
1
Press the » 8 « button to switch
on the appliance.
The appliance starts at the lowest
7
temperature level which takes 10
minutes to reach as long as the
timer setting has not been chan­
ged.
2 Select the required tempera­
ture level with »
HI = high and PU = pulse hig­
her and lower temperatures).
open
« (LO = low,
­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­­
Note
The LO, HI and PU (»pulse«) set­
7
tings are based on the original
duration of 10 minutes, as long
as the timer setting has not been
changed.
3 Select the timer setting with
» « (5, 10 up to maximum of
30 minutes).
Note
Once the set time has elapsed, a
7
signal tone is emitted three times.
4
Press »8« to switch off the ap­
pliance after use.
5
Disconnect the power cord
from the wall socket.
Important note
It is advisable to use the LO =
7
low temperature level. Too hot
steam could cause injury to your
face.
Do not hold your face too near
7
to the mask.
We recommend using the
7
appliance for not longer than 20
minutes per day and not more
than two or three times a week.
You can stop the treatment at
7
any time, by pressing »
switch off.
8 « to
ENGLISH 23