Weatherdock easyAIS A025 Handbuch Seite 10

Quick Instruction
Anschließen leicht gemacht
10 of 28
The only thing you have to do is:
to connect the white (NMEA out +) cable to PIN 2 of the SUB-D9
connector (enclosed in the package).
to connect the green (NMEA out – ) cable to PIN 5 of the SUB-D9
connector (enclosed in the package).
Plug the cable to the serial port of your computer.
If your computer does not have a serial port anymore, which is often the
case with new computers, you can use also a serial<->USB adapter.
But if you use such an adapter please do first install the adapter. Please
assure that the adapter is not yet connected to the easyAIS. In some
cases this could lead to misinstallation of the adapter and a final reliable
use of the easyAIS is not possible.
Select the right input port at your PC
Set transmission data rate to 38400
Set the input port to the following bit configuration: 8/N/1
Weatherdock AG Sigmundstraße 180 D-90431 Nürnberg
Tel.:+49 911 376638-30 www.easyais.de