Care And Cleaning - Klarstein 10031997 Bedienungsanleitung

CARE AND CLEANING

WARNING!
Always disconnect the toaster from the power outlet and allow it to cool
completely before disassembling, cleaning and storage.
Never immerse the toaster, cord or plug in water or other liquid for cleaning.
Never clean the inside of the toaster, as this may damage the heating elements.
Never use a metal scouring pad, abrasive materials, metal polish, harsh chemical
cleaners or hard objects for cleaning any surface of the toaster.
Wipe the outside surfaces and the cord with a soft, dry or slightly dampened cloth
or sponge and a mild detergent.
Remove crumbs after each use
Cleaning the crumb tray
It is important that you remove and clean the crumb tray frequently to avoid the
risk of crumbs catching fi re. The crumb tray is located underneath the heating
elements and can be pulled out from the side of the toaster opposite the browning
control knob.
Pull out the crumb tray completely
Discard the crumbs and wipe the tray clean with a dry or damp cloth.
To remove stubborn spots, use a nylon or plastic scouring pad dampened in soapy
water and squeezed almost dry.
Make sure the tray is completely dry before inserting it back into the toaster.
Do not put the crumb tray in the dishwasher.
Cleaning the removable glass panel
The centre front of the toaster has a full view glass window, which lets you
monitor the toasting progress. The inner panel of this window is removable.
Hold the toaster with one hand and lightly tilt it backwards. With the other
hand, press the latch at the underside and gently pull out the glass panel.
Wipe the panel clean, or wash it in warm, soapy water, rinse and dry thoroughly.
To reinsert the glass panel, lay the toaster on its back, then hold the panel by the latch
and carefully slide it back into the grooves at the side until it clicks securely into place.
EN
29