Instructions - Klarstein 10031997 Bedienungsanleitung

INSTRUCTIONS

Toasting bread
1. Make sure the crumb tray is properly in place before using the toaster. It is located
underneath the heating elements and can be pulled out from the side of the toaster
opposite the browning control dial.
2. Place the toaster on a clean, stable and heat-resistant surface. Make sure that no
liquids or fl ammable objects are near the appliance.
3. Connect the toaster to a properly installed wall socket and switch on the power to
the outlet.
4. Set the browning level with the browning control dial. The browning level may be
adjusted before or straight after pressing down the toasting lever. Seven heating
levels give you precise toasting results. Simply select your desired browning level
based on your needs.
NOTE: When using the toaster for the fi rst time, select setting 3, and then adjust the
setting for successive toast cycles according to your preference. (Use a lower setting for
thin slices.)
5. Place two bread slices side by side in the toasting slot and press the start/cancel
button to start toasting. The bread guides will automatically adjust to hold the food
place and it will automatically lower down to toasting position.
IMPORTANT! Make sure the toaster is connected to your power supply and power is
switched on at the outlet, otherwise the toasting lever will not stay down to start toasting.
6. To stop the toasting cycle at any time, press the CANCEL button
7. While the bread is being toasted, you can watch the process through the viewing
window .
8. When the toast is ready, the toasting lever moves up automatically and the toaster
switches off automatically. You can now remove the bread from the toaster
CAUTION: Do not touch the metal parts of the toaster as they become hot.
9. If toasting more bread, allow the toaster 15 to 20 seconds to cool down in between
toasting cycle so the thermostat can reset.
10. Always unplug the appliance after use and let it cool down before cleaning or
storing.
EN
25