Klarstein 10031997 Bedienungsanleitung Seite 28

EN
28
Toaster isn't working?
If you experience problems with your toaster, check the issues below to ensure it is
properly assembled before you return the appliance to the place of purchase or phone
our after sales support line.
Make sure your toaster is securely plugged in and the power is switched on a
the outlet. The toasting lever will not latch down if there is no power. If you have recently
cleaned the glass panel, make sure the panel is properly installed:
To remove the glass panel, hold the toaster with one hand and lightly tilt it backwards.
With the other hand, press the latch at the underside and gently pull out the glass panel
(see below left). Wipe the panel clean.
To reinsert the glass panel, lay the toaster on its back, then hold the panel by
the latch and carefully slide it back into the grooves at the side until it clicks
securely into place.
IMPORTANT! When reinserting the glass panel, you must ensure that it audibly
·clicks" securely into place, otherwise the toaster will not work. When the panel
"clicks" into place, a safety switch is activated (see below right). This will
ensure your toaster receives power the next time you connect it to your
electricity supply.
Gently pull out the glass panel in
arrow direction.
You must hear it "click' into place to
activate the safety switch (see arrow)