Adjusting The Rotation Time; Setting The Rotation Direction; Starting The Process; Stopping The Process - walser mantona Bedienungsanleitung

6.3 Adjusting the rotation time

Press the "R.T." (rotation time) button several times until the
LED for the desired time lights up (5 - 60 minutes)
Note: You can achieve a faster rotation of the panorama
head by setting a higher value for the rotation angle (e.g.
360°), combined with a shorter run time of, for example, 5
minutes.

6.4 Setting the rotation direction

1. Press the "duration" and "R.T." button at the same time to
set the rotation direction.
2. The first LED (DIR) in the first row indicates the set rotati-
on direction.
DIR LED lights up - clockwise rotation.
DIR LED does not light up - anticlockwise rotation.

6.5 Starting the process

Press the start/stop button to start the process

6.6 Stopping the process

Press the start/stop button to stop the process.
Note
After stopping the rotation process, the rotation process will start over again with the
displayed parameters.
The tripod head must under no circumstances be twisted – this can damage
the internal mechanics.
How to achieve the desired degree marking (e.g. 360°/0) as quickly as possible
- Stop the rotation process by pressing the start/stop button if not already done.
- Determine the lowest rotation movement up to the desired degree marking.
- Set the rotation direction to clockwise or anticlockwise as required.
- Operate the tripod head electrically and make it rotate in the desired direction.
22
- For the fastest possible rotation, adjust the rotation angle to 360° and the duration
to 5 minutes.
- When the desired marking is reached, stop the rotation process.
- To start another rotation process, reset the corresponding operating parameters.
- Start the rotation process again.
When using the tripod head, make sure you are keeping to permitted values for
maximum load-bearing capacity (see section 12. Technical specifications)
When using the tripod head, make sure the mounted equipment is placed as cent-
rally as possible.

7. Maintaining the device

1. Switch off the device. See „Switching device on/off".
2. Remove the camera/equipment and possibly, the connector cable
3. Clean the device if necessary See cleaning the device.
4. Lay the device in the original packaging and store as specified in the technical
specifications. See Technical Data.

8. Troubleshooting

Problem Cleaning
The device is Battery not sufficiently
switched on, but charged
does not show any
function.
Device defective
Device has fallen/ Fall (risk of battery
been dropped damage)
Remedy
Charge battery
Contact the manufacturer
Have the device checked by an
electrician
23