Küppersbusch KD 9570 OBC Bedienungsanleitung Seite 13

Accesories supplied
4 Wall plugs (Ø8 x 40).
4 Long bolts (Ø5 x 45).
2 Wall plugs (Ø6 x 30).
2 Long bolts (Ø4 x 30).
2 Ø6,4 x Ø18, washers.
Installation
Fig. 1
On installing the kitchen hood make sure
that the Safety Instructions set out on page
10 are complied with.
To obtain optimum performance, the external
conduct must not be more than FOUR
METRES long, have no more than two 90°
angles and its diameter must be at least Ø120.
1) Mark and drill the points for fitting the wall
plugs onto the wall (P) (Ø8 x 40). See figure 1.
2) Place the wall plugs and screw the long
long bolts (Q) (Ø5 x 45) with the head of the
screw protruding 5 mm from the wall.
3) Hang the cooker hood onto the long bolts
(Q). Level the unit and tighten the long bolts.
4) Mark the position of the wall plugs (R) (Ø8 x
40) through the inner side of the kitchen hood.
5) Loosen the long bolts (S) (Ø5 x 45) and
remove the hood. If your hood is made of
stainless steel, remove the plastic film before
mounting.
6) Drill the holes and put the wall plugs (R).
7) Hang the hood, tighten the long bolts (Q)
and (S) (Ø5 x 45) with washers (T) (Ø6, 4 x
Ø18).
Active charcoal filters (Optional)
When exterior gas extraction is not possible,
then the kitchen hood may be set to purify the
air by recycling it through active charcoal
filters.
The active charcoal filters have an active life of
between three to six months, depending on the
individual conditions of use. These filters
cannot be washed nor regenerated. They must
be replaced once their useful life comes to an
end.
13