Oxford Presence Lifter Benutzerhandbuch Seite 6

Oxford ®
Presence
3.
Tighten the mast assembly with the mast-locking device, which is located at the front of the
chassis.
Avoid trapping fingers. Keep fingers away from the end of the mast when inserting into the
chassis socket. Full engagement of the mast is indicated by the label on the side of the
mast. The electric leg operation will not function unless the mast is fully engaged.
4.
Turn the locking knob until hand tight.
5.
Line the handle assembly up to the rear of the mast, and attach using the fixings provided. The
fixings and wrench needed to attached the handle are kept in the user instruction wallet for
safe keeping.
NOTE: When attachingthe handle to the mast be sure that all trailing wires are left outside the handle before
fixing.
6.
Fit power pack to the lift and make sure the latch holding the pack in place is fully engaged.
"Click" in place.
6
294000.10007 Rev. D
WARNING
E n g l i s h