Installation / Factory Setting; Channels; Favourite List - Philips DSR 2015 Bedienungsanleitung

INSTALLATION / FACTORY SETTING

After entering the following number combination in the "change PIN" menu, you can reset
changes to the unit settings and restore your unit to its delivery condition (factory setting).
To do this select the "change PIN" menu
All unit settings are reset to the default factory settings:
PIN (protection code): . . . . . . . . . .
Time offset:
Menu language: . . . . . . . . . . . . . . .
Signal paths: TV SCART . . . . . . . .
LNB
DiSEqC
Satellites:
Names of the favourite lists . . . . . .
N.B.:

4.1 CHANNELS

4.1.1 Favourite list

Call up the main menu using the M key and then press the OK key twice.
Sorting, swapping, copying and deleting channels - in one single menu!
"
1. Enter the current PIN:
or:
2. Enter the following PIN:
3. Enter the following PIN:
. . . . . . . . . . . . . . . .
VCR Scart . . . . . . . .
TV -> VCR . . . . . . . .
VCR signal . . . . . . .
Picture format . . . . .
VCR record . . . . . . .
Digital audio . . . . . . .
LNB . . . . . . . . . . . . .
In standby . . . . . . . .
22kHz signal . . . . . .
Tone burst . . . . . . . .
DiSEqC . . . . . . . . . .
DiSEqC repeat . . . . .
Enabling ASTRA . . .
Enabling HOTBIRD .
LO1 . . . . . . . . . . . . .
LO2 . . . . . . . . . . . . .
Orbit pos. ASTRA . . .
Orbit pos. HOTBIRD .
Uncom. switch . . . . .
Check that the time offset is correct and change the menu language as required.
Please note that any changed PIN is also set to 00000.
Key M > Channels > Minor Protection > PIN
X X X X X= the PIN changed by you
0 0 0 0 0 = delivery condition
1 1 1 1 1
9 9 9 9 9
0 0 0 0 0
+1h or +2h, according to date of manufacture
German
RGB
CVBS
ON
RGB/CVBS
4 : 3
Standard
Standard
ON
OFF
High/Low
OFF
ON
OFF
ON
ON
9750 MHz
10600 MHz
1
2
OFF
according to delivery condition