Operating Instructions; Assembly; Handlebar Assembly; Pedal Assembly - Eufab 14500 iBike Miniped Bedienungsanleitung

5.

Operating Instructions

5.1

Assembly

5.1.1

Handlebar assembly

The handlebars of the Miniped are pre-assembled
and just need to be attached to the head tube. Do to
so, loosen the screw (A) and remove the protective
cap (C), see Image 1. Place the handlebars onto the
head tube.
ATTENTION: The electrical cables and
brake lines cannot be twisted, kinked or
clamped.
Straighten the handlebars and tighten both screws (B). Place the screw (A) back in the control head and
tighten it.
5.1.2

Pedal assembly

The pedals are marked with the letter "R" for the
right and "L" for the left side, see Image 2. The right
pedal has a right-hand thread, the left one has a left-
hand thread. Screw the right pedal clockwise into
the threaded hole of the right pedal crank. Screw the
left pedal counter-clockwise into the threaded hole
of the left pedal crank.
5.1.3

Rear mudguard assembly

Place the mudguard on the frame of the back wheel.
Align it with the mounting holes and screw it tight
with both screws, Image 3.
5.1.4

Battery assembly

Insert the key into the lock on the right side of the
battery and turn in a counter-clockwise motion as far
as it will go, Image 4. The battery locking
mechanism is now completely open.
Image 1: Assembling
handlebars
Image 2: Labelling on the pedals
Image 3: Back mudguard
Image 4: Opening the locking
mechanism
the
Page 6 / 16